Danfoss VLT AQUA Drive FC 202 Programming Manual page 102

Parameter Description
10-22 COS Filter 3
Range:
0 [0 -
*
65535 ]
3 3
10-23 COS Filter 4
Range:
0 [0 -
*
65535 ]
3.11.4 10-3* Parameter Access
Parameter group providing access to indexed parameters
and defining programming set-up.
10-30 Array Index
Range:
0 [0 - 255 ] View array parameters. This parameter is valid
*
10-31 Store Data Values
Option:
[0] Off
[1] Store edit
setup
[2] Store all
setups
10-32 Devicenet Revision
Range:
Size related
*
10-33 Store Always
Option: Function:
[0] Off Deactivates non-volatile storage of data.
[1] On Stores parameter data received via DeviceNet in
EEPROM non-volatile memory as default.
100
Function:
Enter the value for COS Filter 3, to set up the
filter mask for PCD 3. When operating in COS
(Change-Of-State), this function filters out bits
in PCD 3 that should not be sent if they
change.
Function:
Enter the value for COS Filter 4 to set up the
filter mask for PCD 4. When operating in COS
(Change-Of-State), this function filters out bits
in PCD 4 that should not be sent if they
change.
Function:
only when a DeviceNet fieldbus is installed.
Function:
Parameter values changed via DeviceNet are not
automatically stored in non-volatile memory. Use
this parameter to activate a function that stores
parameter values in the EEPROM non-volatile
memory, so changed parameter values are
retained at power-down.
Deactivates the non-volatile storage function.
Stores all parameter values from the active set-up
in the non-volatile memory. The selection returns
to [0] Off when all values have been stored.
Stores all parameter values for all set-ups in the
non-volatile memory. The selection returns to [0]
Off when all parameter values have been stored.
Function:
[0 - 65535 ] View the DeviceNet revision number.
This parameter is used for EDS file
creation.
Danfoss A/S © Rev. 2014-01-21 All rights reserved.
Programming Guide
10-34 DeviceNet Product Code
Range:
Size related
10-39 Devicenet F Parameters
Array [1000]
No LCP access
Range:
0 [0 - 0 ] This parameter is used to configure the frequency
*
[0 - 65535 ]
*
Function:
converter via DeviceNet and build the EDS-file.
Function:
MG20O702