Simulating Machining; Overview - Siemens SINUMERIK 840D sl Operating Manual

Simulating machining

5.1

Overview

During simulation, the current program is calculated in its entirety and the result displayed in
graphic form. The result of programming is verified without traversing the machine axes.
Incorrectly programmed machining steps are detected at an early stage and incorrect
machining on the workpiece prevented.
Graphic display
The simulation represented on the screen uses the correct workpiece and tool proportions.
For simulation at milling machines, the workpiece is located, fixed in space. Only the tool
moves, independent of the machine type.
Definition of blank
The blank dimensions that are entered in the program editor are used for the workpiece.
The blank is clamped with reference to the coordinate system, which is valid at the time that
the blank was defined. This means that before defining the blank in G code programs, the
required output conditions must be established, e.g. by selecting a suitable zero offset.
Programming a blank (example)
G54 G17 G90
CYCLE800(0,"TISCH", 100000,57,0,0,0,0,0,0,0,0,0,-1,100,1)
WORKPIECE(,,,"Box",112,0,-50,-80,00,155,100)
T="NC-SPOTDRILL_D16
Note
Blank offset for a changed zero offset
The blank is always created in the zero offset which is presently active.
If you select another zero offset, then the coordinate system is converted, however, the
display of the blank is not changed.
Display of the traversing paths
The traversing paths are displayed in color. Rapid traverse is red and the feedrate is green.
Depth display
The depth infeed is color-coded. The depth display indicates the actual depth at which
machining is currently taking place. The following applies to the color-coded depth display:
"The deeper, the darker".
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
5
209