Creating A Plc Program; Insert Plc Basic Program - Siemens SINUMERIK 804D sl Commissioning Manual

PLC commissioning

7.2 Creating a PLC program

7.2 Creating a PLC program
Introduction
The operator input sequence steps below for the creation of a PLC program describe how to
create a basic program.
The SIMATIC STEP7 documentation describes how to modify and extend an application
program.
7.2.1

Insert PLC basic program

Introduction
You have performed hardware configuration, have saved and compiled the project ad have
created the system data for the PLC.
You have installed the toolbox software, which also contains the libraries for the PLC basic
program of an NCU 7x0.
The following operator input sequence steps describe how to open a library and copy the
sources, the symbols and the individual blocks into your project.
You are on the main screen of the SIMATIC Manager.
Operator input sequence steps to open library and copy sources, symbols and blocks
1. Select the "File > Open" menu and then click on the "Libraries" tab (see figure below).
Figure 7-13
54
Opening the library
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0