Table 8-1. Analog Programming Connector, Designations And Functions - Ametek ASTDC60D1C-E00 Programming Manual

Asterion DC Series Programming
38 DO4 / REV_RY_ON
39 AUX5_EN
*
40
AUXEN_RTN
*
41
AUX15_RTN
42 AUX15_OUT
43 AUX5_OUT
44 AUX15_EN
* With the option, Remote Isolated Analog Interface control, the control signal return is isolated
from the output power negative terminal.
Table 8–1. Analog Programming Connector, Designations and Functions
M330461-01 Rev A
Voltage Rating: Maximum 30 V, Minimum 3V for Active
High,
Current: 4A peak drive, .25A continuous drive capable.
User digital output, cause to be assigned by user or state
of pin 10. Internal to power supply, signal output is from
driver with input signal connected to open-collector of
opto-isolator transistor. Output high state either min 3V
or voltage on pin 30 minus 1V, whichever is higher.
DIGITAL
Signal return: Pin 36, Circuit is electrically connected to
OUTPUT
the output power negative terminal
Voltage Rating: Maximum 30 V, Minimum 3V for Active
High,
Current: 4A peak drive, .25A continuous drive capable.
User digital input, enables output on pin 43. Apply a high
to enable output on pin 43.
DIGITAL
INPUT Signal return: Pin 40, Circuit is electrically connected to
the output power negative terminal
RETURN FOR
Return/GND. Internally, pins 12, 14, 15, 18, 22, 28, 29,
AUXILIARY
36, 40, and 41 are kept at the same DC potential. Circuit
ENABLE
is electrically connected to the output power negative
DIGITAL
terminal.
INPUTS
Return/GND. Internally, pins 12, 14, 15, 18, 22, 28, 29,
RETURN FOR
36, 40, and 41 are kept at the same DC potential. Circuit
AUXILIARY
is electrically connected to the output power negative
5V POWER
terminal.
OUTPUT
AUXILIARY
15V user power output, 1A max current.
USER
Signal return: Pin 41, Circuit is electrically connected to
POWER 15V
the output power negative terminal
OUTPUT
AUXILIARY
5V user power output, 1A max current.
USER
Signal return: Pin 29, Circuit is electrically connected to
POWER 5V
the output power negative terminal
OUTPUT
User digital input, enables output on pin 42. Apply a high
to enable output on pin 42.
DIGITAL
INPUT Signal return: Pin 40, Circuit is electrically connected to
the output power negative terminal
External User Control Signal Connector
8-9