Ametek ASTDC60D1C-E00 Programming Manual page 79

Asterion DC Series Programming
11 0x800
12 0x1000
13 0x2000
14 0x4000
15 0x8000
16 0x10000
17 0x20000
18 0x40000
19 0x80000
M330461-01 Rev A
PFC Fault Internal PFC
module hardware
fault
OCP Fault Output overcurrent
Fault
AUX Supply Auxiliary Supply to
Fault internal hardware
fault
Line Status Input voltage
Changed changed from Low
range to High
range or Vice
versa
Parallel Chassis Parallel
Cable Fault cables PAR
IN/PAR OUT or
CAN IN/CAN OUT
cables are
connected or
disconnected
when power
supply is ON
Salve One of the Slave
System Fault units in Parallel/
Series chassis
configuration NOT
responding
Not Used
Remote Remote voltage
Sense Fault sensing is out of
range from power
supply capacity or
cable connected to
RVS connector
fault
Regulation Power supply not
Fault able to settle to
any of the
operating modes
CC/CV or CP
External User Control Signal Connector
•
Try restarting the power
supply, if fault persists Contact
factory
•
By default, this fault is disabled
and not accessible to user
•
Try restarting the power
supply, if fault persists Contact
factory
•
Make sure input voltage is
stable at one voltage range. If
there is change over in input
voltage range power supply's
output power limits will be
reset based on the limits
specified in datasheet
•
Reset the PAR IN/PAR OUT or
CAN IN/CAN OUT cables as
required and clear the faults
•
Check all slave units in
Parallel/Series chassis
configuration make sure they
are powered ON
•
Power cycle all the units of
Parallel/Series chassis
configuration
•
Check if the cable connected
to RVS connected at rear side
power supply is intact and
polarity is correct.
•
Check the output cable voltage
drop and make sure voltage
drop across cable is not
exceeding limit specified in
datasheet
•
Try restarting the power
supply, if fault persists Contact
factory
8-23