Digital Outputs - Ametek ASTDC60D1C-E00 Programming Manual

Asterion DC Series Programming
1. To enable the 5V output remotely following SCPI command to be used:
OUTP:AUX:5V ON
2. To enable the 15V output remotely following SCPI command to be used:
OUTP:AUX:15V ON
3. To Enable the 5V output from remote Digital Input:
Apply a high at pin 39 to enable output on pin 43. Return Pin is 40.
Voltage Rating: Maximum 24 V, Minimum -5V
Low state 0.3 V max, High State 2.7 V min.
4. To Enable the 15V output from remote Digital Input:
Apply a high at pin 44 to enable output on pin 42. Return Pin is 40.
Voltage Rating: Maximum 24 V, Minimum -5V
Low state 0.3 V max, High State 2.7 V min.

Digital outputs

8.5.2
DC Asterion power supply provides four digital outputs.
Digital Output 1: Provides Low state at Constant Voltage (CV) mode of
operation and High state at Constant Current (CC) operation. Output signal
Pin is 25 and return pin is 28 or 36.
Digital Output 2: Provides High state at Constant Power (CP) mode of
operation otherwise remains at low state. Output signal Pin is 27 and return pin
is 28 or 36.
Digital Output 1 and Output 2 states reflects the query response of following
SCPI command.
SOUR:CURR:MODE? ------ Returns the mode of operation of the power supply.
0 - Constant Voltage operation,
1 - Constant Current operation and
2 - Constant Power operation
Command
SOUR:CURR:MODE?
Digital Output 3 (OUT_RY_ON): Output Signal (Pin 37, Return Pin 28 or 36)
can be made high by using high signal on the Digital input (Pin 11, Return Pin
12) or by issuing following SCPI Command.
OUTP:ISOL ON
Digital Output 4 (REV_RY_ON): Output Signal (Pin 38, Return Pin 28 or 36)
can be made high by using high signal on the Digital input (Pin 10, Return Pin
12) or by issuing following SCPI Command
OUTP:POL ON.
M330461-01 Rev A
External User Control Signal Connector
Response Digital Output-1
0 Low State
1 High State
2 Low State
Digital Output-2
Low State
Low State
High State
8-19