Network Setup Using Static Ip; Figure 6-6. Lan Configure (Settings); Figure 6-7. Lan Screen (Configure Static Ip) - Ametek ASTDC60D1C-E00 Programming Manual

Asterion DC Series Programming
9. Identify the IP address assigned to the power supply by following ways.
a. Discovering it with a VXI-11 compliant discover program.
b. Using front panel and navigating to Home  Control Interface  LAN  LAN
Settings. Refer to Figure 6-4.
c. Using a computer serial communications program such as Tera Term, set for
the same baud as Asterion DC power supply (see Figure 6-5) no parity, 8 data
bits, 1 stop bit. Use SCPI command SYST:NET:IP? <Enter> to get the IP
address.
10. The Asterion DC power supply Ethernet hardware is now configured. Open Web
browser and enter the IP address of the power supply to view the Home page of
the power supply. Refer to Figure 6-10.

Network Setup using Static IP

6.4.3
This setup requires that DHCP is OFF. DHCP mode can be made OFF using the front
panel or using the serial interface.
6.4.3.1 S IP
TATIC
Navigate to Home  Control Interface  LAN  LAN Configure. Make the
DHCP as OFF, See Figure 6-2. LAN Screen (Configure). IP address button will
be enabled.
1. Enter the required IP address, Subnet Mask and Gateway (Refer to Figure 6-6).
2. Press "Apply" button for the settings to take effect.
3. The Asterion DC power supply Ethernet hardware is now configured. Open Web
browser and enter the IP address of the power supply to view the Home page of
the power supply. Refer to Figure 6-10 .
M330461-01 Rev A
SETUP USING FRONT PANEL

Figure 6-6. LAN configure (Settings)

Upon Pressing the IP Address, keypad to enter IP address will pop-up.

Figure 6-7. LAN Screen (Configure Static IP)

Ethernet Configuration and Remote Programming
6-11