Ethernet Configuration Factory Defaults; Rear Panel; Figure 6-1. Rear Panel - Ethernet Interface - Ametek ASTDC60D1C-E00 Programming Manual

Asterion DC Series Programming

Ethernet Configuration Factory Defaults

6.2.1
PARAMETER
Host Name
Description
IP Address
Subnet Mask
Gateway
DNS Server
Listening Port
User ID
Password
* The Ethernet interface provides the opportunity to assign an IP address via Auto-
IP. If DHCP server fails to assign an IP address and Auto-IP setting is ON, the unit
gets an IP address in the range of 169.254.X.X.

REAR PANEL

6.3
This section provides illustrations of the Asterion DC power supplies rear panel layout,
which differs among the Asterion models. For example, refer to Figure 6-1. Rear Panel
- Ethernet Interface. Regardless of the layout, the component functions are common
across all models and those that are pertinent to the Ethernet option are described
here.
1-RJ45-Ethernet connector
2- Remote Analog Programming and External User Control Interface Connector
M330461-01 Rev A
Ethernet Configuration and Remote Programming
AST<base model>-<last four digits of serial number>
AST Power Supply <base model>
* DHCP-acquired, If DHCP server absent, assigned via
Auto-IP
* DHCP-acquired, If DHCP server absent, assigned via
Auto-IP
* DHCP-acquired, If DHCP server absent, assigned via
Auto-IP
0.0.0.0
52000
admin
password

Figure 6-1. Rear Panel - Ethernet Interface

DEFAULT
6-7