Remote/Local Selection
Local Lock out Mode:
3.1.2
•
Using the interface available on the unit (RS232, USB, LAN, GPIB), Sending the
command SYST:LOCAL:LOCK will change the unit to Local Lock out mode.
•
During this mode, All the front panel options and hardware buttons will be
disabled.
•
To enable the device into local mode, use the special command
SYST:LOCAL:UNLOCK "6867", unit mode will be changed to local mode. Refer
to Figure 3-4
3-2
Figure 3-3. Local Lockout Screen
Figure 3-4. Home-Screen
Asterion DC Series Programming
M330461-01 Rev A