Usb Setup Procedure; Port Number Identification - Ametek ASTDC60D1C-E00 Programming Manual

Ethernet Configuration and Remote Programming

USB SETUP PROCEDURE

5.2

Port Number Identification

5.2.1
Port Number of the Asterion DC power supply can be identified in the device manager
by following the steps below:
1. Navigate to device manager in the windows system.
2. Go to Ports and check for the new COM port available in the list.(Refer to
Figure 5- 2)
3. Note: If Multiple COM ports are shown, disconnect all the COM ports and
connect only the Asterion DC power supply and check for the new COM port.
5-2
Figure 5- 2 Port identification
Asterion DC Series Programming
M330461-01 Rev A