Remote/Local Selection; Introduction; Remote Mode; Figure 3-1. Local/Remote Screen - Ametek ASTDC60D1C-E00 Programming Manual

INTRODUCTION

3.1
This section describes the various mode of operations available in the front
panel.

Remote mode:

3.1.1
•
Unit can be set to Remote mode by Sending the command SYST:LOCAL 0 using
any of the interface available on the unit (RS232,USB,LAN, GPIB).
•
Note: Unit can also be set to remote by sending any SCPI command using any of
the interface available on the unit. (Refer to Figure 3-1)
•
Upon pressing the Go To Local button Asterion DC power supply front panel
screen will navigate to Dash board. (Refer to Figure 3-2)
M330461-01 Rev A

REMOTE/LOCAL SELECTION

Figure 3-1. Local/Remote Screen

Figure 3-2. Dashboard Screen

3
3-1