Ametek ASTDC60D1C-E00 Programming Manual page 129

Asterion DC Series Programming
CAL:OUTP:VOLT:DAC 19000
10. Let the output settle and measure the voltage with a high precision voltmeter;
this is value 2.
11. Enter the actual output voltage value of the second calibration point:
CAL:OUTP:VOLT:FIVEPOINT 2 <value 2>
12. Program the output of the third calibration point by sending the following
command
CAL:OUTP:VOLT:DAC 32000
13. Let the output settle and measure the voltage with a high precision voltmeter;
this is value 3.
14. Enter the actual output voltage value of the third calibration point:
CAL:OUTP:VOLT:FIVEPOINT 3 <value 3>
15. Program the output of the fourth calibration point by sending the following
command
CAL:OUTP:VOLT:DAC 45000
16. Let the output settle and measure the voltage with a high precision voltmeter;
this is value 4.
17. Enter the actual output voltage value of the fourth calibration point:
CAL:OUTP:VOLT:FIVEPOINT 4 <value 4>
18. Program the output of the fifth calibration point by sending the following
command
CAL:OUTP:VOLT:DAC 62250
19. Let the output settle and measure the voltage with a high precision voltmeter;
this is value 5.
20. Enter the actual output voltage value of the fifth calibration point:
CAL:OUTP:VOLT:FIVEPOINT 5 <value 5>
21. To review entered data for five–point voltage calibration, issue the following
query:
M330461-01 Rev A
External User Control Signal Connector
string from
string from
string from
the computer:
the computer:
the computer:
10-47