Auxiliary Bus Bank - Sony DVS-7300 User Manual

Auxiliary Bus Bank

The auxiliary bus bank controls the
selection of signals output from the unit,
and of signals used for video masking.
AUX
BLACK
1 Cross-point buttons
2 Source name display
1 Cross-point buttons
The leftmost 29 cross-point buttons in
each row are allocated to the same signals
as the cross-point buttons in the M/E
banks (and PGM/PST bank on the BKDS-
7021/7022/7023). At the right, there are
also three reentry buttons (M/E-1, M/E-2,
and M/E-3) to select the output from any
of the M/E banks.
The 29 buttons from the left act as buttons
numbered 0 to 28 when the SHIFT button
5 is not pressed. When the SHIFT button
is held down, these buttons select the
signals numbered 30 to 58. If, however, in
a setup menu you have allocated the 29th
button from the left as a shift button, then
the same operation as with the M/E cross-
point button is possible.
The cross-point buttons serve a total of 19
buses, including AUX 1 to AUX 13 and
the edit preview bus. Before selecting the
3 Delegation buttons
4 Selected signal display
AUX DELEGATION
AUX AUX AUX AUX AUX AUX AUX AUX AUX
1 2 3 4 5 6 7 8 9
Auxiliary bus bank
signal, delegate the cross-point buttons
with the appropriate delegation button 3.
2 Source name display
This displays the identifiers of the signals
which can be selected with the cross-point
buttons. When there are two signals
allocated to a cross-point button, hold
down the SHIFT button 5 to show the
identifiers assigned to the shifted buttons.
Holding down the shift button in the cross-
point button row also displays the
identifiers assigned to the shifted buttons.
If you are using the switcher and a DVS-B
series routing switcher connected by a
BKDS-7700, the signal names set on the
routing switcher can be displayed.
5 SHIFT button
6 Programmable
button
7 PV/K button
FRAME FRAME
FDIT M/E
AUX AUX AUX AUX
MEM MEM
PVW UTIL
10 11 12 13
1 2
COLOR
BKGD
Chapter 2 Location and Function of Parts
V/K
SHIFT
M/E M/E M/E
SHIFT
1 2 3
2-27