Sony DVS-7300 User Manual page 525

Programmable button Functions available for allocation
AUX BLANK: NO ASSIGN: No function allocated. (Factory default
Unlabeled button to
the right of the V/K
AUX OR EXT: When you press the button, turning it on,
button (above the shift
button) in the auxiliary
bus bank (see page
AUX14-28: Pressing this button, turning it on, displays
2-27)
Operation when "AUX OR EXT" is selected
To switch the 16 destinations of a routing switcher
which can be controlled from the switcher, use the 16
delegation buttons (AUX1 to AUX13, EDIT PVW,
FRAME MEM 1, and FRAME MEM 2) in the auxiliary
bus bank.
For source switching, use the cross-point buttons. The
button (button number 0) at the left end of the cross-
point button row corresponds to source 1 controlled
from the switcher, and using the shift function a
maximum of 59 sources can be switched.
ORTHG: ORTHG ORTHG: The trackball functions as a positioner only in
button in the DME
control section
VTR: The DME control section functions as a VTR tape
Specify one of the 12 sub-register selection buttons as
ALL: ALL button in the
numeric keypad the button to be selected when the ALL button is
section pressed.
TR TYPE NAM & NAM & SUPER MIX: Select NAM and SUPER MIX as
SUPER MIX: NAM
and MIX buttons in
KEY1, KEY2 ON: Assign the same functions as the
the transition control
section of each M/E
bank
KEY1, KEY2 MIX: Assign the same functions as the
WIPE/DME: Set DIRECTION (NORM, NORM/REV, or
DSK WIPE/DME DIR:
NORM, NORM/REV,
and REV buttons,
blank button to the
PVW SELECT: The following functions apply.
right of the REV
button, and blank
button to the right of
the DME button in
the P/P DSK control
section
setting)
the auxiliary bus bank control switches to the routing
switcher.
AUX 14 to AUX 28 in the auxiliary bus bank, and
enables cross-point switching.
the one of the X- and Y-directions in which it is moved
more. (Factory default setting)
transport controller.
the respective transition types. (Factory default setting)
KEY1 ON and KEY2 ON buttons in the M/E key control
section.
KEY1 MIX and KEY2 MIX buttons in the M/E key
control section.
REV) for the execution of a WIPE/DME transition.
(Factory default setting)
NORM: Select M/E1 PVW on the EDIT PVW bus.
NORM/REV: Select M/E2 PVW on the EDIT PVW bus.
REV: Select M/E3 PVW on the EDIT PVW bus.
Blank button right of REV: Select EXT (DIRECT IN) on
the EDIT PVW bus.
Blank button right of DME: Select PST on the EDIT
PVW bus.
(Continued)
14-69
Chapter 14 Setup