14
Select the MASTER signal to which you wish to allocate a LINK
signal, using either of the following methods:
• Hold down F3 (MASTER) and press the required cross-point button in
the auxiliary bus bank.
• Hold down F3 (MASTER) and use the cursor movement keys to select
the required cross-point button.
• Hold down F3(MASTER) and turn control knob 2.
• Hold down F3(MASTER) and enter the required cross-point button
number using the numeric keypad.
15
Select the LINK signal you wish to allocate to the MASTER, using
either of the following methods.
• Hold down F6 (LINK) and press the required cross-point button in the
auxiliary bus bank.
• Hold down F6 (LINK) and use the cursor movement keys to select the
required cross-point button.
• Hold down F6(LINK) and turn control knob 3.
• Hold down F6(LINK) and enter the required cross-point button number
using the numeric keypad.
Linking a button to a GPI output port
After carrying out steps 1 to 4 of the procedure in the previous section,
"Linking operations on two buses", continue with the following steps.
5
Press F9 (MASTER/LINK) to set F9 to "MASTER".
The indication for F10 changes to "MASTER SELECT".
6
Press F10 (MASTER SELECT) or turn control knob 3 to align the cursor
with the button you wish to select as the master button (the button
causing the GPI output), then press F8 (SELECT).
This selects the button with which the cursor is aligned as the "master
button".
7
Press F9 (MASTER/LINK) to set F9 to "LINK".
The indication for F10 changes to "LINK SELECT".
(Continued)
14-81
Chapter 14 Setup