Table of Contents
Advertisement
2
Carry out the operation in the following table to make the required
setting.
Setting
Setting the screen saver
delay time
Selecting the control over
each of banks given to the
control panel
Setting the fade-to-black
function
Operation
Press F1 (SCREEN SAVER).
This cycles the setting through OFF, 1, 3, 5, and 10.
Press one of F3 (M/E-1), F4 (M/E-2), F5 (M/E-3), and
F6 (P/P).
This cycles the setting through INHBT, DSBL, and
ENBL.
Press F7 (DSK1) to F10 (DSK4) for the
corresponding downstream keyer.
This toggles the setting between ENBL and DSBL.
Note
When two or more DSKs are enabled, the same
transition rate is used for all of them. When the
DMK-7000 cascade mode is used, enable only the
last DSK. If more than one DSK is enabled when in
cascade mode, the fade-to-black will not be executed
at the correct transition rate.
14-77
Chapter 14 Setup
Hide quick links:
Advertisement
Chapters
Table of Contents
