Sony DVS-7300 User Manual page 467

To carry out these settings, use the following procedure.
1
In the SYSTEM menu, press F4 (SYSTEM CONFIG).
The SYSTEM CONFIGURATION menu appears.
SYSTEM DMK
CONFIG
CONFIG
PAIR CASCAD
F1 F2 F3
Function key indications in the SYSTEM CONFIGURATION menu
2
Carry out the operation in the following table to make the required
setting.
Setting
Selecting the system
configuration
Selecting the DMK-7000
configuration
Setting the switcher
program output
Setting the final bank
controlled through the
PANEL 2 connector of the
switcher
Adjusting the switcher
output signal phase
Adjusting the DMK-7000
output signal phase
Setting the color
correction and frame
memory function
configuration
Multiple cross-point
assignment
You may press F6 and F7 together to adjust the switcher and DMK-7000
output signal phases simultaneously.
SYSTEM PHASE
REMOTE
SWER PANEL
PGM PGM SWER DMK
M/E-3 M/E-1
F4 F5 F6 F7
Operation
Press F2 (SYSTEM CONFIG).
This toggles the setting between SEPA and PAIR.
Press F3 (DMK CONFIG).
This cycles the setting through CASCAD, PARA,
INDPND and DUAL.
Press F4 (SWER PGM).
This cycles the setting through M/E-1, M/E-2 and
M/E-3.
Press F5 (REMOTE PANEL PGM).
Pressing this button cycles through M/E-1, M/E-2,
M/E-3, P/P, and AUX.
When you selected AUX, set an AUX bus number
with control knob 3.
Press F6 (SWER), turning it to reverse video, and
adjust control knob 4.
Press F7 (DMK), turning it to reverse video, and
adjust control knob 4.
Press F9 (FM&CCR CONFIG) to display the CCR
CONFIGURATION menu.
For details, see the next section.
Press F10 (MLT XPT ASSIGN) to display the MULTI
XPT ASSIGN menu.
For details see page 14-13.
FM&CCR MLT XPT
CONFIG ASSIGN
F8 F9 F10
14-11
Chapter 14 Setup