Sony DVS-7300 User Manual page 357

Path settings within an M/E bank
Making path settings for individual items within an M/E bank
For example, in the case of the M/E-1 bank, use the following procedure.
For the M/E-2 and M/E-3 banks, use a corresponding procedure.
1
In the SWER KF PATH menu, press F2 (M/E-1).
The function key indications change as follows.
KEY1
LINEAR
F1
2
Press one of F1 (KEY1) to F6 (CHR KEY) to select the corresponding
curve path type.
Pressing each of F1 to F6 cycles through the settings in the order shown
below. F1 (KEY1), F2 (KEY2), F4 (TRANS), and F6 (CHR KEY) cycle
through four settings excluding "SPLINE".
OFF t STEP t LINEAR t S-CURVE t SPLINE
The selected path type is shown on the menu display by an icon.
3
If you selected "SPLINE" in step 2, adjust control knobs 1 to 3 as
follows.
Knob Parameter
1
2
3
4
Press F10 (HUE PATH), then select the HUE path type.
For details, see steps 4 and 5 in the previous section "Setting the paths
for all banks".
CURVE
KEY2 WIPE TRANS
LINEAR LINEAR LINEAR
F2 F3 F4
Setting
Tension Degree of tension between points (–4.000 to +4.000)
Bias Degree of inclination of tangent at point (–4.000 to +4.000)
Continuity Degree of continuity at point (–4.000 to +4.000)
COLOR CHR
KEY DSBL
BKGD
LINEAR LINEAR
F5 F6 F7
Chapter 8 Key Frame Effects
XPT HUE
PATH
OFF
F8 F9 F10
8-23