Overview; Saving And Recalling Setup Data - Sony DVS-7300 User Manual

Overview

To operate a system comprising a switcher unit, control panel and DMK-
7000 connected together, it is necessary to access the various setup menus,
and make various settings. These settings are referred to as setup data.
For details of menu operation, see the section "Basic Menu Operations"
(page 3-6).

Saving and Recalling Setup Data

Default values for all settings on the switcher unit, control panel and DMK-
7000 (default setup data) are held in ROM in the individual units.
Using the setup menus, you can create a set of customized setup data (user
setup data) held in RAM. The setup data in RAM in each unit is lost when
the unit is powered off or reset, but you can also save the user setup data in
nonvolatile memory or on a 3.5-inch floppy disk (using the floppy disk drive
in the control panel).
The setup data in nonvolatile memory in each unit is automatically loaded
into RAM when the unit is powered on or reset.
If the resume function is on (F7 or F8 set to ON in the SYSTEM SETUP
menu (see page 14-7)), the setup data held in RAM is saved when the unit is
reset or powered off and it is used again after the unit is reset or next powered
on.
14-2
Chapter 14 Setup
ROM
Default setup data
"SWER ALL CLEAR"
and "DMK ALL CLEAR"
in SETUP menu (see
page 14-17)
RAM
"BACKUP" in SETUP
menu (see page 14-15)
Nonvolatile memory
Saving and recalling setup data
3.5-inch floppy disk
User setup data
"SETUP LOAD"
in DISK menu
(see page 10-12)
Current setup data
When resume function is off.
• Reset or power on
• "SWER RESET" or "DMK
RESET" in SETUP menu (see
page 14-17)
User setup data
"SETUP SAVE"
in DISK menu
(see page 10-12)