Sony DVS-7300 User Manual page 520

Setup Relating to Operations From the Control Panel
(OPERATION Menu)
14-64
Chapter 14 Setup
2
Select the cross-point button to which you wish to assign an input signal,
using either of the following methods.
• Hold down F1 (BUTTON No.) and press the required cross-point
button in the auxiliary bus bank.
• Hold down F1 (BUTTON No.) and use the cursor movement keys to
select the required cross-point button.
• Hold down F1 (BUTTON No.) and turn control knob 2.
• Hold down F1 (BUTTON No.) and enter the required cross-point
button number using the numeric keypad.
The indication of the button you have pressed switches to reverse video.
3
Press F8 (SOURCE SELECT) or turn control knob 3 to move the cursor
and select the required input signal.
If you do not want to assign VIDEO SOURCE, press F2 (INHIBIT), and
if you do not want to assign KEY SOURCE, press F5 (INHIBIT).
4
To confirm the VIDEO SOURCE assignment, press F3 (SELECT), and
to confirm the KEY SOURCE assignment, press F6 (SELECT).
5
Press F10 (SOURCE NAME).
The SOURCE NAME menu appears.
SOURCE
SELECT
#2
F1 F2 F3
Function key indications in the SOURCE NAME menu
6
Press F2 (SOURCE SELECT) or turn control knob 2 to move the cursor
and select the signal to which you wish to assign a name.
7
Either press F8 (NAME SELECT) or turn control knob 3 to move the
cursor; or either press F9 (USER NAME SELECT) or turn control knob
4 to move the cursor, and then select the required signal name.
To enter a new signal name
Press F8(NAME SELECT), and then select USER in the list of example
signal names.
SELECT
F4 F5 F6 F7
USER SET
NAME USER
NAME
SELECT SELECT NAME
#3 #4
F8 F9 F10