Executing And Saving Effects; Executing Effects - Sony DVS-7300 User Manual

Executing and Saving Effects

Executing Effects

You can execute, or play back, the currently recalled effect, using either the
RUN button or the fader lever, to obtain a continuous segment of video. Use
the following procedures.
Note
For the following operations, first press and light the appropriate buttons for
the sub-registers to which execution is to apply.
Execution with the fader lever (manual mode)
To execute the whole effect manually, move the fader lever smoothly from
one end of its travel to the other.
• When the REV button is lit: the effect executes in the reverse direction.
• When the STOP NEXT KF button is lit: the effect stops at the next key
• When a pause time point is set: the effect executes up to the pause point.
To execute the effect up to an intermediate point, stop moving the fader
lever at the intermediate point. If you then move the fader lever again, the
effect resumes execution. By moving the fader lever in the reverse direction
you can execute the effect in the reverse direction.
Execution with the RUN button (auto mode)
To execute the effect automatically, press the RUN button. If any of the
REV, STOP NEXT KF, and PAUSE buttons are lit, the effect is the same as
in manual mode.
To execute the effect up to an intermediate point, press the RUN button
again during execution. Press the RUN button once more to resume
execution.
8-26
Chapter 8 Key Frame Effects
frame.
In this case, wait at least 0.5 second before executing the next key frame. If
you move the fader lever in the reverse direction immediately, the next key
frame may not be executed correctly.