Sony DVS-7300 User Manual page 485

Carrying out setup relating to DMK-7000 output signals (DMK
OUTPUT menu)
You can use the two menu screens accessible from the DMK OUTPUT menu
for the following settings.
Settings in screen 1
You can make the same settings as in screen 1 of the SWITCHER OUTPUT
menu (see page 14-25) relating to the DMK-7000 output signals.
Settings in screen 2
You can make the same settings as in screen 2 of the SWITCHER OUTPUT
menu (see page 14-25) relating to the DMK-7000 output signals.
Note, however, there are the following differences between the two menus.
• Setting to determine use of a switcher output for input to the DMK-7000
does not apply to the DMK OUTPUT menu.
• In the DMK OUTPUT menu, you can set the vertical blanking interval for
each output signal individually.
To carry out the settings using the DMK OUTPUT menu, proceed as follows.
1
In the INPUT/OUTPUT menu, press F6 (DMK OUTPUT).
The DMK OUTPUT menu appears.
F1
2
Carry out the operation in the same way as for steps 2 and 3 of the
operating procedure under the section "Carrying out setup relating to
switcher output signals (SWITCHER OUTPUT menu)" (see page 14-
25).
Output signals selectable for the settings made in screen 2
DSK1 to DSK4 PROGRAM OUTPUTS,
DSK1 to DSK4 PREVIEW/KEY OUTPUT, CLEAN OUT,
DME-I/F VIDEO OUTPUT, DME-I/F KEY OUTPUT
OUTPUT OUTPUT
ADJUST1
ADJUST2
F2 F3 F4 F5
Function key indications in the DMK OUTPUT menu
F6 F7 F8 F9
Chapter 14 Setup
F10
14-29