Sony DVS-7300 User Manual page 214

DME Wipes
Using a DME wipe for a key transition
4-130
Chapter 4 Basic Operations for Image Creation
To use a DME wipe for a key transition, use the following procedure.
1
Select the key for the next transition.
M/E key: In the transition control section, press the next transition
selection button KEY 1 or KEY 2, turning it on.
Downstream key: In the downstream keyer control section, press one of
the keyer selection buttons DSK 1 through DSK 4, turning it on.
In a 3.5-M/E system, you can alternatively press one of the next
transition selection buttons DSK 1 through DSK 4 in the PGM/PST
bank transition control section, turning it on.
2
When inserting the key, select the key type, key fill, and key source, and
make any necessary settings such as key modifications.
Note
When inserting an M/E key, set the key source selection to "AUTO
SELECT" or "SPLIT" (see page 4-52). If you set it to "KEY BUS", the
key source signal will not be transmitted correctly to the DME, and
therefore the key transition will not be executed correctly.
3
Select DME wipe as the transition type.
M/E key: In the transition control section, press the transition type
selection button DME 1 or DME 2, turning it on.
Note
You cannot specify dual mode for a key transition using a DME
wipe.
Downstream key: In the downstream keyer control section, press the
transition type selection button DME, turn it on.
In a 3.5-M/E system, you can alternatively press the DME button in
the PGM/PST bank transition control section, turning it on.
4
Select the DME wipe pattern, and if required adjust the parameters.
For details of this operation, see the next section "DME Wipe Settings".