Sony DVS-7300 User Manual page 247

5
Press F1 (MIX) once again, turning it on.
The main and subsidiary patterns are combined.
6
Press one of F4 to F7 to select the type of pattern combination.
F4 (MIX): Combine the main and subsidiary patterns by a "mix".
F5 (+NAM): Combine the main and subsidiary patterns by a "positive
NAM".
F6 (–NAM): Combine the main and subsidiary patterns by a "negative
NAM".
F7 (MORPH): Evolve through the course of the transition, from the
main pattern, to the subsidiary pattern.
7
If necessary, adjust the "Mix" parameter.
When one of F4 to F6 is selected
Knob Parameter
1 Mix
When F7 is selected
Set the Start and End parameters. The start point of the transition
corresponds to 0.00, and the end point to 100.
Knob Parameter
1 Start
2 End
If you specify a negative value: When the transition starts, combining
of the main and subsidiary patterns has already begun.
If you specify a value greater than 100: Combining of the main and
subsidiary patterns is still continuing when the transition ends.
If the End value is more than the Start value: As the transition
progresses, the change is from the subsidiary pattern to the main
pattern.
Setting
Degree to which subsidiary pattern is combined with
main pattern (0.00 to 100.00)
Setting
Position in transition when main pattern is 100%
(–50.00 to +150.00)
Position in transition when subsidiary pattern is
100% (–50.00 to +150.00)
Chapter 4 Basic Operations for Image Creation
(Continued)
4-163