Sony DVS-7300 User Manual page 515

5
Press F4 (FIELD) to select the GPI trigger output timing.
Pressing this button cycles through the settings: ANY (arbitrary timing),
F1 (first field), and F2 (second field).
6
Press F9 (ACTION SELECT) or turn control knob 3 to align the cursor
with the desired action causing the GPI output.
• If you selected F1 (GPI) for DEVICE1 or DEVICE2, select "GPI
MODE."
• If you selected F4 (P2TL) for DEVICE1, select "TL MODE."
7
Press F7 (SELECT) to confirm the selection of the action causing the
GPI output.
8
Repeat steps 2 to 7 to make the settings for the other output ports.
Setting the VTR control time code
To set the VTR control time code used in the control panel, use the following
procedure.
1
In the PANEL PORT ASSIGN menu, press F2 (VTR IF).
The VTR INTERFACE menu appears.
TC SOURCE
VTR 1 VTR 2
LTC LTC
F1 F2 F3
Function key indications in the VTR INTERFACE menu
2
Press F1 for VTR1 or F2 for VTR2.
The selection cycles through LTC, VITC, L/VI (LTC/VITC) and CTL.
To set the VTR program play mode
You can play back at a preset speed.
To set the playback speed, in the VTR INTERFACE menu, for VTR1 press
F4, and for VTR2 press F5, setting the indication to "PGM". Set the speed
with knob 4.
You can set the playback speed in the range approximately ±20% of standard
playback speed.
PLAY MODE
VTR 1 VTR 2
NORMAL NORMAL
F4 F5 F6 F7 F8 F9 F10
Chapter 14 Setup
14-59