Sony DVS-7300 User Manual page 60

Auxiliary Bus Bank
3 Delegation buttons
Press one of these buttons, turning it on, to
delegate the cross-point buttons to the
corresponding bus.
AUX 1 to AUX 13 buttons: These
correspond to auxiliary buses 1 to 13.
The signals on these buses are output
from the connectors on the rear panel
labeled AUX BUS OUTPUTS 1 to 13.
EDIT PVW (preview) button: This
corresponds to the edit preview bus.
The signal on this bus is output from
the connector on the rear panel labeled
EDIT PVW OUTPUT.
FRAME MEM (memory) 1 and 2
buttons: These correspond to frame
memory buses 1 and 2. The signals
selected on these bases are input to
frame memory 1 and 2.
M/E UTIL button: This corresponds to
the utility buse for the three M/E
banks.
4 Selected signal display
This displays the identifier of the source
signal currently selected on each bus.
5 SHIFT button
Hold down this button and press a cross-
point button to select one of the signals
numbered 30 to 58. At this time the
identifiers assigned to the shifted buttons
are displayed.
2-28
Chapter 2 Location and Function of Parts
6 Programmable button
By means of a SETUP menu setting, you
can use this button for switching the
auxiliary bus bank between controlling the
auxiliary buses and controlling a routing
switcher, or for switching between
auxiliary buses 1 to 13 and auxiliary buses
14 to 28.
For details, see the section "Changing
switcher functions (OPERATION MODE
menu)" (page 14-66).
7 V/K button
Use this button when selecting the signal
assigned to an auxiliary bus at the key
level.
While this button is held down, in the
auxiliary bus bank the key signals on the
auxiliary bus selected by the delegation
button are displayed.