Basic Operation For Key Settings Using The Key Control - Sony DVS-7300 User Manual

Basic Operation for Key Settings Using the Key Control

Section
You can carry out some M/E bank key setting operations using the buttons
and knobs (numbered 1 to 3 from top to bottom) in the key control section.
Selecting the keyer
To make settings for keyer 1, first press the KEY 1 button in the key control
section to delegate the key control section to keyer 1.
Use the same method to delegate the key control section to keyer 2.
Selecting the key type
To select the key type, press one of the key type selection buttons.
For an overview of each key type, see the page number indicated in
parenthesis.
LUM button: luminance key (page 4-39)
LIN button: linear key (page 4-40)
CLEAN button: clean key (page 4-40)
CHR button: chroma key (Chapter 5)
PTN button: pattern key (page 4-40)
The button you have pressed lights green, and you can now adjust the
parameters using the control knobs.
While the LUM, LIN or CLEAN is lit green:
Knob
1
2
3
While the CHR button is lit green:
Knob
3
Parameter Setting
Clip Set clip level on the key signal (–10 to +110)
Gain Set key sharpness (0 to 100)
Density Set key density (0 to 100)
Parameter Setting
Density Set key density (0 to 100)
Chapter 4 Basic Operations for Image Creation
4-67