Sony DVS-7300 User Manual page 508

Setup Relating to Interfaces With Peripheral Devices
(PERIPH Menu)
14-52
Chapter 14 Setup
For the DMK-7000:
• On the PGM/PST bank: CUT, AUTO TRANS (auto transition)
• On each DSK: CUT, AUTO TRANS (auto transition), FTB CUT
(cut-to-black), FTB (fade-to-black)
• SS RECALL (recall snapshot), EFF RECALL (recall effect),
RECALL & RUN (recall and run effect), KF RUN (run key frame),
KF STOP (stop key frame), KF REWIND (rewind key frame)
Combinations of operating bank/function and trigger action
In this menu you can select different trigger actions from the GPI input for
each operating bank or function, but not all combinations are possible. Only
those combinations which are available appear on the menu screen.
For snapshot and key frame actions, it is not possible to make different
settings for different banks or functions. If you make different settings for
different banks or functions, the most recent setting applies to all banks or
functions.
To carry out these settings, use the following procedure.
Note
Disable the GPI ports using the port enable function of the MISC menu (see
page 12-2) beforehand. After completing the settings with the GPI INPUT
menu, enable the GPI ports using the MISC menu.
1
In the PERIPH menu, press F7 (GPI INPUT).
The GPI INPUT menu appears.
PORT TRIGGER
DEVICE
SELECT TYPE
SELECT
#2
F1 F2 F3
Function key indications in the GPI INPUT menu
2
Press F1 (DEVICE SELECT) to move the cursor and select the switcher
(SWER) or DMK-7000 (DMK) as the device to which the settings apply.
The menu display changes according to the selection you make.
REGION
SELECT SELECT
ALL
F4 F5 F6
ACTION
SELECT
#3
F7 F8 F9 F10