Sony DVS-7300 User Manual page 154

Keys
Parameter adjustments with the BKDS-7271 installed
• While the BORD or OUTLINE button is lit green:
Knob
1
3
• While the DROP BORD or SHDW button is lit green:
Knob
1
2
3
a) For the details of "4H DROP ON" and "4H DROP OFF" modes, see "Edge types and key fill/
Selecting an unmodified edge
When all four of the edge type selection buttons are off, an unmodified
("normal") edge is selected. If one of the buttons is lit, press it, turning it off.
Using the processed key function
To use the processed key function to apply special effects to the key using a
DME, press the PROC KEY button, turning it on.
For details of the processed key function, see page 4-65.
Key snapshot operations
Using the key snapshot function, you can save all of the key settings, except
the key on or off state, in a dedicated register. Recalling a snapshot restores
all the settings instantly. There are four snapshot registers per keyer.
To save a key snapshot
For example, to save the state of keyer 1, first press the KEY 1 button in the
key control section to delegate the key control section to keyer 1, then hold
down the SNAPSHOT button in the FlexiPad for the corresponding M/E
bank, and then press one of the key snapshot buttons 1 to 4 in the key control
section.
This saves a snapshot in the register corresponding to the number of the
button pressed.
4-70
Chapter 4 Basic Operations for Image Creation
Parameter
Width
Density
Parameter
Width
Position
Density
key source positions" (page 4-58).
Setting
Set width (0 to 100)
Set density (0 to 100)
Setting
Set width (0 to 100)
Set position (in "4H DROP ON"
a)
DROP OFF" mode: 180 to 359)
Set density (0 to 100)
a) mode: 0 to 359 b) ; in "4H