Setting The Transition Rate - Sony DVS-7300 User Manual

Executing a Transition

Setting the Transition Rate

You can set the rate of an auto transition, by specifying the duration as the
number of frames required. Use the following procedure to set the transition
rate before pressing the AUTO TRANS button to carry out an auto transition.
To set the transition rate, first specify the bank or keyer for which you wish
to carry out the setting, then enter the numeric value from the numeric
keypad section.
Setting the transition rate
Setting the transition rate for one of the M/E banks or the PGM/
PST bank
To set the transition rate for one of these banks, use the following procedure.
1
2
3
4
Adjusting the duration
Instead of entering a new value, you can enter the difference from the current
setting. First press the +/– button, then enter a signed value, and then finally
press the TRIM button.
Pressing the +/– button toggles between positive and negative values.
4-32
Chapter 4 Basic Operations for Image Creation
Press the TRANS RATE button in the numeric keypad section.
Press the sub-register selection button corresponding to the bank for
which you wish to set the new transition rate, turning it on.
M/E-1, M/E-2, and M/E-3 buttons: M/E banks
P/P DSK button: PGM/PST bank
This displays the transition duration set for the selected bank in the
numeric keypad section.
Enter the required number of frames for the transition duration in the
numeric keypad section.
Press the ENTER button.
This confirms the entered value, which appears in the display of the
numeric keypad section.
For an M/E bank or the PGM/PST bank, the set duration also appears in
the FRAMES display.