Sony DVS-7300 User Manual page 463

Making various system settings (SYSTEM SETUP menu)
You can use the SYSTEM SETUP menu for the following settings.
• Setting the date: Set the calendar in the switcher.
• Setting the time: Set the clock in the switcher.
• Selecting the signal format: Select the signal format as one of D2-525,
D1-525 and D1-625.
• Toggling the 7.5 IRE setup on or off (D2-525 systems only)
• Setting the screen aspect ratio: Select 4:3 or 16:9 as the screen aspect
ratio.
• Selecting the video switching timing: Select the fields on which video
switching occurs from among ANY, EVEN and ODD (for D2 systems)/
ANY, F1 (1st field) and F2 (2nd field) (for D1 systems).
• Selecting the state at power on: Specify whether the switcher and control
panel settings at power on are the settings when the unit was last
powered off (resume function ON) or the settings saved using the
BACKUP menu (resume function OFF).
Regardless of this selection, the signal format setting at power on is
always the same as when the unit was last powered off.
• Alarm setting: Select whether to sound (ON), or not (OFF) an audible
alarm when an error state occurs. Even when this is set to OFF, error
messages still appear on the menu screen.
Note
Of the above, the settings relating to the signal format, the 7.5 IRE setup, and
the screen aspect ratio also apply to the DME automatically.
To carry out these settings, use the following procedure.
1
In the SYSTEM menu, press F3 (SYSTEM SETUP).
The SYSTEM SETUP menu appears.
DATE
F1
SIGNAL 7.5 SCREEN
TIME FORMAT SETUP FORMAT
F2 F3 F4 F5
Function key indications in the SYSTEM SETUP menu
SWITCH PANEL
TIMING RESUME RESUME ALARM
ANY OFF OFF
F6 F7 F8
Chapter 14 Setup
ON
F9 F10
(Continued)
14-7