Sony DVS-7300 User Manual page 505

To carry out these settings, use the following procedure.
1
In the PERIPH menu, press F5 (DME IF).
The DME INTERFACE menu appears.
RE-ENTRY
DME BUTTON
No.
SELECT OFF
#2
F1 F2 F3
Function key indications in the DME INTERFACE menu
2
Press F1 (DME SELECT) or turn conrol knob 2 to move the cursor and
select the required DME input to which the settings apply.
3
Make the required settings in the order of (1) to (4) as shown in the table
below.
Setting
(1) Making the reentry
cross-point button
setting
(2) Making the
auxiliary bus
setting for output
to DMEs
(3) Setting the on-air
tally function
(4) Assigning DMEs
for DME wipes
ON AIR
TALLY SELECT
SELF
F4 F5 F6
Operation
Hold down F3 (BUTTON No.) and press the required
cross-point button in the auxiliary bus bank. Alternatively,
hold down F3 and turn control knob 2 to make the
selection.
When not using reinput to the switcher
Press F2 (OFF), switching the REENTRY indication to
OFF.
Use the following procedure.
1 Press F8 (BUS SELECT) or turn control knob 3 to move
the cursor and select the required auxiliary bus output.
2 Press F6 (SELECT) to confirm the selection.
Press F4 (ON AIR TALLY).
This toggles the setting between SELF and OFF.
Use the following procedure.
1 Press F10 (DME ASSIGN), to display the function key
indications for DME assignment.
2 Press F2 (M/E SELECT) or turn control knob 2 to move
the cursor and select one of the following banks: M/E-1,
M/E-2, M/E-3 or P/P DSK.
3 Press F6 (DME SELECT) or turn control knob 3 to
move the cursor and select the required DME.
If not using the DME wipe function, select "NO
ASSIGN".
4 Press F4 (SELECT) to confirm the DME selection.
BUS DME
SELECT ASSIGN
#3
F7 F8 F9 F10
Chapter 14 Setup
14-49