Infineon Technologies C166S V2 User Manual page 210

0, 1 : Constant Values
:.... : Each of the 4 characters immediately following a colon represents a single bit
:..ii : 2-bit short GPR address (Rwi)
SS : Code segment number
:..## : 2-bit immediate constant (#irang2)
:.### : 3-bit immediate constant (#data3)
...#:# : 5-bit immediate constant (#data5)
c : 4-bit condition code specification (cc)
d : 5-bit condition code specification (xcc)
n : 4-bit short GPR address (Rwn or Rbn)
m : 4-bit short GPR address (Rwm or Rbm)
q : 4-bit position of the source bit within the word specified by QQ
qqq : 3-bit addressing mode specifier for CoXXX instructions
z : 4-bit position of the destination bit within the word specified by ZZ
# : 4-bit immediate constant (#data4)
t:ttt0 : 7-bit trap number (#trap7)
QQ : 8-bit word address of the source bit (bitoff)
rr : 8-bit relative target address word offset (rel)
rrr : 3-bit repeat control for CoXXX instructions
RR : 8-bit word address reg
wwww:w : 5-bit word address CoREG
X : 4-bit addressing mode specifier for CoXXX instructions
ZZ : 8-bit word address of the destination bit (bitoff)
## : 8-bit immediate constant (#data8)
## xx : 8-bit immediate constant (represented by #data16, byte xx is not significant)
@@ : 8-bit immediate constant (#mask8)
MM MM : 16-bit address (mem or caddr; low byte, high byte)
## ## : 16-bit immediate constant (#data16; low byte, high byte)
a : 1-bit branch assumption bit
l : 1-bit short backward loop bit
User Manual
Detailed Instruction Description
8-210
User Manual
C166S V2
V 1.7, 2001-01