Component Update; Storage, Assembly And Transport - WAGO 750-830 Manual

2.4 Component Update

For the case of an Update of one component, the lateral marking on each com-
ponent contains a prepared matrix.
This matrix makes columns available for altogether three updates to the entry
of the current update data, like production order number (NO; starting from
calendar week 13/2004), update date (DS), software version (SW), hardware
version (HW) and the firmware loader version (FWL, if available).
Update Matrix
Current Version data for:
Production Order
Number
Datestamp
Software index
Hardware index
Firmware loader
index
If the update of a component took place, the current version data are registered
into the columns of the matrix.
Additionally with the update of a field bus coupler or controller also the cover
of the configuration and programming interface of the coupler or controller is
printed on with the current manufacturing and production order number.
The original manufacturing data on the housing of the component remain
thereby.

2.5 Storage, Assembly and Transport

Wherever possible, the components are to be stored in their original packag-
ing. Likewise, the original packaging provides optimal protection during
transport.
When assembling or repacking the components, the contacts must not be
soiled or damaged. The components must be stored and transported in appro-
priate containers/packaging. Thereby, the ESD information is to be regarded.
Statically shielded transport bags with metal coatings are to be used for the
transport of open components for which soiling with amine, amide and sili-
cone has been ruled out, e.g. 3M 1900E.
WAGO-I/O-SYSTEM 750
BACnet/IP Controller
Technical Condition of the Devices
1. Update 2. Update
NO
DS
SW
HW
FWL
Component Update
3. Update
" only starting from calendar
week 13/2004
" only for coupler/controller
• 21