WAGO 750-830 Manual page 269

750-635, 753-635
The above Digital Pulse Interface module has a total of 4 bytes of user data in
both the Input and Output Process Image (3 bytes of module data and 1 byte of
control/status). The following table illustrates the Input and Output Process
Image, which have 2 words mapped into each image. Word alignment is ap-
plied.
RTC Module
750-640
The RTC Module has a total of 6 bytes of user data in both the Input and Out-
put Process Image (4 bytes of module data and 1 byte of control/status and 1
byte ID for command). The following table illustrates the Input and Output
Process Image, which have 3 words mapped into each image. Word alignment
is applied.
DALI/DSI Master Module
750-641
The DALI/DSI Master module has a total of 6 bytes of user data in both the
Input and Output Process Image (5 bytes of module data and 1 byte of con-
trol/status). The following tables illustrate the Input and Output Process Im-
age, which have 3 words mapped into each image. Word alignment is applied.
WAGO-I/O-SYSTEM 750
BACnet/IP Controller
Input and Output Process Image
Byte Destination
Offset
High Byte
0 D0
1 D2
Input and Output Process Image
Byte Destination
Offset
High Byte
0 ID
1 D1
2 D3
Process Data Architecture for MODBUS/TCP
Low Byte
C0/S0 Data byte
D1
Low Byte
C/S Command byte
D0
D2
I/O Modules
Remark
Control/Status byte
Data bytes
Remark
Control/Status byte
Data bytes
• 269