WAGO 750-830 Manual page 102

102 • BACnet/IP Controller 750-830
Programming the PFC Using WAGO-I/O-PRO CAA
3.1.8.5 System Events
Fig. 3-7: System events
In place of a task, a system event can also call up a project module for proc-
essing.
The system events to be employed for this depend on the target system. These
events consist of the list of supported standard system events for the control
system and any other manufacturer-specific events, which may have been
added. Possible events, for example: . Stop, Start, Online change.
A complete list of all system events is provided at WAGO-I/O-PRO CAA /
"Resources" tab" / "Task configuration" / "System events".
A module is called up by the event when the corresponding item is activated;
i.e., when there is a check in the check box in the first column. Activation or
deactivation is done with a mouse click on the check box.
Additional Information
Allocation of the system events to the specific modules to be called up is clari-
fied in the manual for the programming tool WAGO-I/O-PRO CAA at
http://www.wago.com
Documentation ! WAGO-I/O-SYSTEM 759 ! WAGO-I/O-PRO !
759-333
under:
p912277d
WAGO-I/O-SYSTEM 750
BACnet/IP Controller