WAGO 750-830 Manual page 104

104 • BACnet/IP Controller 750-830
Programming the PFC Using WAGO-I/O-PRO CAA
The following standard entries are shown in the center dialog window:
• Port: COM1
• Baud rate: 19200
• Parity: Even
• Stop-bits: 1
• Motorola byteorder: No
If necessary, change the entries accordingly by clicking on the respective
value and editing it.
5. Confirm these settings by clicking OK
The RS232 port is now configured for transferring the application.
Additional information
For details on installing the communication drivers and using the software,
refer to the WAGO-I/O-PRO CAA. The manual available at
http://www.wago.com
! WAGO-I/O-PRO ! 759-333
Note
The controller mode selector switch must be at either the center or top posi-
tion to access the controller.
6. Under Online, click the menu item Login to log in to the controller.
If there is no program in the controller, a window appears asking whether or
not the program is to be loaded.
7. Respond with Yes to load the current program.
8. Once the program has been loaded, start program processing in the menu
9. To terminate online operation, click the menu item Log off in the Online
under: Documentation ! WAGO-I/O-SYSTEM 759
(The WAGO-I/O-PRO CAA Server is active during online operation. The
communication parameters cannot be called up during this time.)
Online, menu item Start.
"ONLINE" and "RUNNING" will then appear at the right of the status bar.
menu.
WAGO-I/O-SYSTEM 750
BACnet/IP Controller