WAGO 750-830 Manual page 103

3.1.8.6 Transfer of IEC 61131-3 Program
Transfer from the PC to the controller of the program for the created IEC
61131-3 application can be performed two ways:
• Direct transfer via serial RS232 port
• Transfer by means of TCP/IP via fieldbus
Suitable communication drivers are required for transfer; these can be config-
ured using WAGO-I/O-PRO CAA under Online / Communication parameters.
Note
When selecting an appropriate driver, ensure that the communication parame-
ters are set and matched accordingly.
3.1.8.6.1 Transfer via Serial Service Port
Use the WAGO communication cable to set up a physical connection via se-
rial service port. This is included in the scope of supply for the programming
software WAGO-I/O-PRO CAA (Item No.: 759-333) or can be procured as an
accessory item under order no. 750-920.
Notice
The communication cable 750-920 may not be connected or removed when
the system is energized; i.e., there must be no power to the controller!
Use the WAGO communication cable to connect the COMX port of your PC
to the controller communication port.
A communication driver is required for serial data transfer. This driver and its
parameters must be entered in the WAGO-I/O-PRO CAA in the dialog win-
dow "Communication parameters".
1. Start the WAGO-I/O-PRO CAA software under Start \ Programs \
2. In the menu Online select the item Communication parameters
The dialog window "Communication parameters" then appears. This window
is empty in its default settings.
3. Click New to set up a link and then enter a name, such as RS232.
4. In the selection window, mark the required driver in the right side of the
WAGO-I/O-SYSTEM 750
BACnet/IP Controller
Programming the PFC Using WAGO-I/O-PRO CAA
WAGO-I/O-PRO and WAGO-I/O-PRO CAA.
window, Serial (RS232) – 3S Serial RS232 driver, to configure the serial
link between the PC and the controller.
BACnet/IP Controller 750-830 • 103