WAGO 750-830 Manual page 93

Note
The number of modules that send or receive data must correspond to the
existing hardware (except for supply modules, copying modules or end mod-
ules, for example). The number of input and output bits or bytes of the indi-
vidually connected bus modules can be found in the corresponding descrip-
tions of the bus modules.
Additional Information:
To obtain further information about an I/O module, either select that module
from the catalog, or in the current configuration and then click the button
Data Sheet. The module is then shown in a separate window with its associ-
ated data sheet.
Note
For the current version of the data sheets go to
Documentation.
8. Click OK to accept the node configuration and close the dialog window.
The addresses for the control system configuration are then recalculated and
the tree structure for the configuration updated.
If required, you can also modify the authorization privileges for individual
modules if they are to be accessed via fieldbus (MODBUS/TCP/IP). Initially,
write access from the PLC is defined for each module that is added. Proceed
as follows to change this setting:
9. Click on a module in the configuration.
10. In the right dialog window under the tab
module data is to be carried out.
WAGO-I/O-SYSTEM 750
BACnet/IP Controller
Programming the PFC Using WAGO-I/O-PRO CAA
"Module parameters" define for each module from where access to the
You can choose from the following settings in the column "Value" for this:
• PLC (standard setting)
• MODBUS TCP/UDP
• MODBUS RTU
• BACnet
BACnet/IP Controller 750-830
http://www.wago.com
- Access from PFC
- Access from MODBUS/TCP
- Access from MODBUS/RTU
- Access from BACnet/IP
• 93
under