WAGO 750-830 Manual page 80

80 • BACnet/IP Controller 750-830
Fieldbus Node Start-up
3.1.7.1.3 Testing for Proper Functioning of the Fieldbus Node
1. Set up a (non-serial) link between the client PC and the controller to test
2. Call up the DOS prompt window: Start / Programs / DOS prompt.
3. Type the command ping using the IP address you have assigned, with the
4. When you press the Return key the controller sends a reply to your client
5. If the test is successful, you can close the DOS window. The node is now
communication with the controller and correct assignment of the IP ad-
dress. The client PC must be equipped with a network card for this.
following syntax:
ping [space] XXXX . XXXX . XXXX . XXXX
Fig. 3-1: Example for a fieldbus node function test
PC that is displayed in the DOS prompt window.
Should the error message "Request timeout" appear, check your input
against the IP address you assigned.
ready to communicate.
G083070e
WAGO-I/O-SYSTEM 750
BACnet/IP Controller