WAGO 750-830 Manual page 118

118 • BACnet/IP Controller 750-830
Programming the PFC Using WAGO-I/O-PRO CAA
BACnet
You can set the transmission rate of the internal data bus and the UDP port on
the "BACnet" page.
In the "UDP Port" field, enter the UDP port for BACnet/IP that is to be used.
If you place a check mark in the "Non-adaptive internal data bus transmission
rate in ms" box (default setting), the transmission rate will be constant and
will not be adapted to the node configuration.
This not only helps reduce the run-up time, but it also reduces the transmission
rate. Remove the check mark to increase the transmission rate.
Abb. 3-18: Web-based Management System: BACnet
WAGO-I/O-SYSTEM 750
BACnet/IP Controller