Relinquish_Default - WAGO 750-830 Manual

6.68 Relinquish_Default

Data Type
Objects
Description
WAGO-I/O-SYSTEM 750
BACnet/IP Controller
List of all BACnet Properties in Native Operation
Binary Input:
{NO_FAULT_DETECTED, NO_SENSOR, OPEN_LOOP,
SHORTED_LOOP, UNRELIABLE_OTHER}
Binary Output:
{NO_FAULT_DETECTED, NO_OUTPUT, OPEN_LOOP,
SHORTED_LOOP, UNRELIABLE_OTHER}
Analog Input:
{NO_FAULT_DETECTED, NO_SENSOR,
OVER_RANGE, UNDER_RANGE, OPEN_LOOP,
SHORTED_LOOP, UNRELIABLE_OTHER}
Analog Output:
{NO_FAULT_DETECTED, OPEN_LOOP,
SHORTED_LOOP, NO_OUTPUT,
UNRELIABLE_OTHER}
Schedule:
The property Reliability indicates whether the properties of
the schedule object are constant. All non-ZERO values used
in the Weekly_Schedule, the Exception_Schedule, and the
Schedule_Default properties shall be of the same data type,
and all members of the
List_Of_Object_Property_References shall be writable with
that data type. If these conditions are not met, then this
property shall have the value CONFIGURATION_ERROR.
The Reliability property for this object may have any of the
following values:
{NO_FAULT_DETECTED, CONFIGURATION_ERROR,
UNRELIABLE_OTHER}
If the List_Of_Object_Property_References contains a
member that references a property in a remote device, the
detection of a configuration error may be delayed until an
attempt is made to write a scheduled value.
see Objects
Binary Output (BACnetBinaryPV), Analog Output (REAL)
This property is the default value to be used for the Pre-
sent_Value property when all command priority values in
the Priority_Array property have a ZERO value.
Relinquish_Default
• 305