WAGO 750-830 Manual page 79

After a brief period, the 'I/O' LED lights up green, meaning the fieldbus con-
troller is operational. If an error occurred during start-up, an error code is indi-
cated by a red, flashing 'I/O' LED.
If error code 6 is indicated, followed by error argument 4 by the "I/O" LED af-
ter run-up of the controller with red flashing of error code six times, followed
by red flashing of the error argument four times, this indicates that an IP ad-
dress has not yet been assigned.
3.1.7.1.2 Assigning of IP Addresses to Fieldbus Nodes
The following provides examples of fieldbus node IP address allocation using
the "WAGO ETHERNET Settings" Program.
Note
The program "WAGO-ETHERNET Settings" is available for downloading at
http://www.wago.com
The program is also included on the CD "AUTOMATION Tools and Docs"
(Item No.: 0888-0412) available from WAGO.
1. Start the WAGO-ETHERNET Settings program.
2. Click on Identify to identify the controller connected to the system.
3. Select the tab TCP/IP (see Fig. 3-2)
Fig. 3-2: Setting IP addresses using WAGO ETHERNET Settings
4. Enter the desired IP Address and, if applicable, the address of the subnet
5. Click the button Write to transfer this address to the controller.
6. Click on Call WBM. An Explorer then opens with the Web-based man-
WAGO-I/O-SYSTEM 750
BACnet/IP Controller
under: Downloads ! AUTOMATION.
mask and gateway.
agement system in which you can make all further settings (see section
3.1.8.7).
BACnet/IP Controller 750-830
Fieldbus Node Start-up
• 79
g084906d