WAGO 750-830 Manual page 52

52 • BACnet/IP Controller 750-830
Hardware
3.1.3.5 Configuration Interface and Programming Interface
The configuration interface is located behind the cover flap. It is used for
communication with WAGO-I/O-CHECK, WAGO-I/O-PRO CAA and for
downloading firmware.
Configuration and
programming interface
Fig. 3-3: Configuration Interface
The communication cable (750-920) is connected to the four-pole header.
Notice
The 750-920 Communication cable may not be connected or removed when
the system is energized; i.e., there must be no power to the coupler/controller!
g01xx07e
WAGO-I/O-SYSTEM 750
BACnet/IP Controller