WAGO 750-830 Manual page 94

94 • BACnet/IP Controller 750-830
Programming the PFC Using WAGO-I/O-PRO CAA
Fig. 3-5: Write access over module parameters
After completing these settings you can begin with IEC 61131-3 program-
ming. The "EA-config.xml" configuration file is generated as soon as the pro-
ject has been transferred.
Additional Information:
For a detailed description of how to use the WAGO-I/O-PRO CAA software
and the I/O Configurator, refer to the online help function for WAGO-I/O-
PRO CAA.
Note
You can also create the file "EA-config.xml" using an editor and store it in
the controller directory "/etc" by means of FTP.
Configuration using the file "EA-config.xml" that is already stored in the
controller is described in the following section.
3.1.8.1.1.1 Configuration Using the "EA-config.xml" File
Note
If you wish to perform module assignment directly using the "EA-
config.xml" file stored in the controller, do not save any configuration data in
WAGO-I/O-PRO CAA prior to this, as the file is overwritten by entries in the
WAGO-I/O-PRO CAA on each download.
1. Open any FTP client. You can also use the Windows FTP client in the
2. Type in the IP address of the controller to access the controller file system.
3. Then, enter admin as the user login and wago as the password.
4. The file "EA-config.xml" is located in the "etc" folder. Copy this file to a
DOS prompt window.
local directory on your PC and open it in an editor installed on your PC
(e.g., "WordPad").
g083023e
WAGO-I/O-SYSTEM 750
BACnet/IP Controller