WAGO 750-830 Manual page 266

266 • I/O Modules
Process Data Architecture for MODBUS/TCP
Serial Interface Modules with Standard Data Format
750-650/000-001, -014, -015, -016
750-651/000-001
750-653/000-001, -006
The above Serial Interface Modules with Standard Data Format have a total of
6 bytes of user data in both the Input and Output Process Image (5 bytes of se-
rial data and 1 byte of control/status). The following table illustrates the Input
and Output Process Image, which have a total of 3 words mapped into each
image. Word alignment is applied.
Data Exchange Module
750-654, (and the variation /000-001)
The Data Exchange modules have a total of 4 bytes of user data in both the
Input and Output Process Image. The following tables illustrate the Input and
Output Process Image, which has a total of 2 words mapped into each image.
Word alignment is applied.
Input and Output Process Image
Byte Destination
Offset
High Byte
0 D0
1 D2
2 D4
Input and Output Process Image
Byte Destination
Offset
High Byte
0 D1
1 D3
Low Byte
C/S Data byte
D1
D3
Low Byte
D0
D2
Remark
Control/Status byte
Data bytes
Remark
Data bytes
WAGO-I/O-SYSTEM 750
BACnet/IP Controller