WAGO 750-830 Manual page 107

ETHERNET
Over the "Ethernet" link, you will reach a website on which you can configure
the bandwidth limit and transmission rate for ETHERNET communication.
With the BACnet/IP Controller, you will use Port 1 while setting the transmis-
sion rate ("Speed Configuration") (see Tab. 3-20).
Tab. 3-20: Set transmission rate ("Speed Configuration")
Parameter
Enable Port
Enable Power-Save Mode Activates the energy saving mode for the ETHERNET port
Enable Auto MDI-X
Enable Autonegotiation
10 MBit Half Duplex
10 MBit Full Duplex
100 MBit Half Duplex
100 MBit Full Duplex
Enable IEEE 802.3x
Full Duplex Flow Control
A bandwidth limit function can also be configured for the ETHERNET port.
The following modes can be configured under Section "Bandwidth/Sniffer
Configuration" in the option fields "Limit mode":
Mode
ALL
BC MC FU Broadcast, multicast and flooded-unicast data packets are limited
BC MC
BC
WAGO-I/O-SYSTEM 750
BACnet/IP Controller
Programming the PFC Using WAGO-I/O-PRO CAA
Description
Deactivates the ETHERNET port. Both ports cannot be deac-
tivated at the same time.
Activates the Auto MDI-X function of the ETHERNET port.
The "Auto MDI-X" function employs an internal switching
functionality to allow the use of either crossed (Crossover) or
straight-in (Patch) cables.
Activates the autonegotiation function of the ETHERNET
port. The "Autonegotiation" function enables automatic de-
termining (negotiating) of the best-possible baud rate and the
optimal transfer mode between two link partners.
Configures the ETHERNET port for a baud rate of 10 MBit,
with a half duplex transfer mode.
Configures the ETHERNET port for a baud rate of 10 MBit,
with a full duplex transfer mode.
Configures the ETHERNET port for a baud rate of 100 MBit,
with a half duplex transfer mode.
Configures the ETHERNET port for a baud rate of 100 MBit,
with a full duplex transfer mode.
Activates automatic flow control for the full duplex transfer
mode
Description
All ETHERNET data packets are limited
Broadcast and multicast data packets are limited
Broadcast data packets are limited
BACnet/IP Controller 750-830 • 107