Component Update; Storage, Assembly And Transport - WAGO -I/O-SYSTEM 750 Technical Description, Installation And Configuration

2.4 Component Update

For the case of an Update of one component, the lateral marking on each
component contains a prepared matrix.
This matrix makes columns available for altogether three updates to the entry
of the current update data, like production order number (NO; starting from
calendar week 13/2004), update date (DS), software version (SW), hardware
version (HW) and the firmware loader version (FWL, if available).
Update Matrix
Current Version data for:
Production Order
Number
Datestamp
Software index
Hardware index
Firmware loader index FWL
If the update of a component took place, the current version data are registered
into the columns of the matrix.
Additionally with the update of a fieldbus coupler or controller also the cover
of the configuration and programming interface of the coupler or controller is
printed on with the current manufacturing and production order number.
The original manufacturing data on the housing of the component remain
thereby.

2.5 Storage, Assembly and Transport

Wherever possible, the components are to be stored in their original
packaging. Likewise, the original packaging provides optimal protection
during transport.
When assembling or repacking the components, the contacts must not be
soiled or damaged. The components must be stored and transported in
appropriate containers/packaging. Thereby, the ESD information is to be
regarded.
Statically shielded transport bags with metal coatings are to be used for the
transport of open components for which soiling with amine, amide and
silicone has been ruled out, e.g. 3M 1900E.
WAGO-I/O-SYSTEM 750
PROFINET IO
Technical Condition of the Devices
1. Update 2. Update 3. Update
NO
DS
SW
HW
Component Update
Only starting from
calendar week 13/2004
Only for coupler/
controller
• 15