Alarm Status - Alcatel-Lucent 7705 Service Manual

VLL Services Command Reference
Label
Dro. OutProf
ATM SAP Configuration Information
Ingress TD Profile
Egress TD Profile
Alarm Cell Handling
OAM Termination
CEM SAP Configuration Information
Endpoint Type
Bit-rate
Payload Size
Jitter Buffer
Use RTP Header
CAS Framing
Effective PVDT
Cfg Alarm

Alarm Status

Page 284
Table 34: Show Service-ID All Command Output Fields (Continued)
Description
Indicates the number of out-of-profile packets or octets
discarded
The profile ID of the traffic descriptor applied to the ingress
SAP
The profile ID of the traffic descriptor applied to the egress
SAP
Indicates that OAM cells are being processed
Indicates whether this SAP is an OAM termination point
Specifies the type of endpoint
Specifies the number of DS0s or timeslots in the channel group
Specifies the number of octets contained in the payload of a
TDM PW packet when the packet is transmitted
Specifies the size of the receive jitter buffer, expressed in
milliseconds
Specifies whether RTP headers are used in CES packets (Yes
or No)
Specifies the type of CAS framing
Displays the peak-to-peak packet delay variation (PDV) used
by the circuit emulation service.
Since the operating system may adjust the jitter buffer setting
in order to ensure no packet loss, the configured jitter buffer
value may not be the value used by the system. The effective
PVDT provides an indication that the PVD has been adjusted
by the operating system (see
Specifies the alarms that have alarm reporting enabled
Indicates the current alarm state (for example, stray,
malformed, packet loss, overrun, underrun, remote packet loss,
remote fault, or remote RDI)
7705 SAR OS Services Guide
Jitter Buffer on page 154
)