Alcatel-Lucent 7705 Service Manual page 324

VLL Services Command Reference
Page 324
Table 42: SDP Output Fields (Continued)
Label
Hello Time
Hello Msg Len
Max Drop Count
Hold Down Time
Statistics
I. Fwd. Pkts.
I. Dro. Pkts.
I. Fwd. Octs.
I. Dro. Octs.
E. Fwd. Pkts.
E. Fwd. Octets
Eth-Cfm Configuration Information
Md-index
Direction
Ma-index
Admin
MepId
CCM-Enable
LowestDefectPri
HighestDefect
Defect Flags
Mac Address
CcmLtmPriority
CcmTx
Description
Specifies how often the SDP Echo Request messages are
transmitted on this SDP
Specifies the length of the SDP Echo Request messages transmitted
on this SDP
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive
protocol reports a fault
Specifies the amount of time to wait before the keepalive operating
status is eligible to enter the alive state
Specifies the number of forwarded ingress packets
Specifies the number of dropped ingress packets
Specifies the number of forwarded ingress octets
Specifies the number of dropped ingress octets
Specifies the number of forwarded egress packets
Specifies the number of forwarded egress octets
Displays the value of the MD index
Displays the direction of the MEP
Displays the value of the MA index
Displays the administrative state of the MEP (enabled or disabled)
Displays the MEP-ID
Displays the status of the Continuity Check Message (CCM)
Displays a configured value that defects are evaluated against
Displays the highest defect
Indicates the defect flags
Displays the MAC address (the MAC address for a spoke SDP is
the system MAC address; for a SAP, it is the port MAC address)
Displays the priority of the CCM Linktrace Message (LTM)
Displays the number of CCM transmissions
7705 SAR OS Services Guide